​If you are the owner of a house in Southern Maryland, then you might have come across with the water pressure problems in your home. Even if the water pressure issues are just intermittent or irregular flow or complete pressure loss, the problem at most times occurs at inconvenient times. There are various kinds of water pressure problems that are experienced by homeowners. Some might just experience pressure problems in bits and pieces whereas some might experience constant low water pressure. Whatever is the water pressure problem, it is very important to get it checked up by an expert in plumbing services so that you enjoy constant water pressure in your home. One of the problems that you can face is the failure of the well pump pressure switch.

What is a pressure switch?
This is a switch that will give signals to the well pump to start or to stop pumping. It will be functioning depending on the pressure in the water system. These pressure switches will have two types of pressure settings: cutoff and cut-in pressure. The pressure settings are numbers that are seen on the pressure switch it. They will be seen as 40-60, 30-50 or 20-40 psi. The lower number is when the pressure switch starts to kick in and fill up the pressure tank. Once the reading goes to the highest number the pump will stop. The lower and the higher pressure settings can be adjusted depending on your water supply needs and requirements. The pressure switch will be seen in the basement of your house, garage or pool area.

How Does A Well Pump Pressure Switch Fail? 
The pressure switch will be having springs to set the pressure and also has the electric wiring to give the signal to the pump to switch on and off. The most common problems seen in the switch are corrosive to the wire ports or loosening of the springs after regular use. If the contacts are rusted and detached completely, then the pressure switch will not function at all. There are times when the pressure switch might need a replacement due to wear and tear.

When Do You Need To Call A Plumbing Experts?
The following are some of the problems that could be the symptoms that indicate that the pressure switch is malfunctioning or has failed.

These symptoms may or may not be due to pressure switch issues. If you experience any of these issues, it is better to seek the help of certified and professional well pump pressure switch experts to take a look at the pump system. Calling the experts early whenever you experience problems in water pressure is very important so that the problems can be arrested as quickly as possible. This way you might not have to get the get the entire switch replaced and it might only need some cleaning or tightening.

Request Service

Enter your contact details here to help us serve you better & faster.


Satisfaction Guaranteed

Are You In Need Of A Plumbing Estimate?